A two pack fast drying micaceous iron oxide, high solids, high build epoxy primer
Jotun Penguard Express MIO is specially designed for new construction where short dry to handle and overcoating times are required. It can be used as a primer and intermediate coat in atmospheric environments on steel, concrete, aluminium and galvanised steel. It is suitable for use as a primer or intermediate coat in aggresive C5M environments, recommended for offshore locations, bridges, buildings and mining equipment.
Jotun Penguard Express MIO is a fast drying high build two pack amine cured epoxy primer designed for new construction where fast dry to handle and overcoating times are required. Penguard Express MIO is suitable for use on steel to be exposed to highly corrosive C5M environments. It can be applied by Airless spray, Conventional spray or brush and can be applied at sub zero temperatures. It is prequalified in accordance with Norsok M501 System 1. Jotun Penguard Express MIO is resistant to continuous temperatures of up to 120°C
Penguard Express MIO is a two pack epoxy matt suitable for use in atmospheric environments as a primer or intermediate coat in a multicoat system. It can be applied direct to carbon steel, galvanised steel, aluminium and concrete surfaces. It is recommended for offshore environments, structural steel, power plants, building products, construction and steel bridges. It can be applied up to 250 microns in a single coat by airless spray, two coats may be required to achieve the recommended DFT by brush or roller.
Carbon Steel: Minimum Sa 2.5 (ISO 8501-1)
Galvanised steel: Surface to be clean and dry with a rough dull surface
Aluminium: Surface to be clean and dry, abrade with non metallic abrasives or pads
Concrete: Max moisture content 5%, mechanically abrade the surface to remove laitance
Painted surfaces: Surface to be clean, dry and undamaged compatible coating, free from oil grease and other contaminants.
|Penguard Express MIO
||Penguard Express MIO Comp A
||Penguard Express Comp B
Volume Solids (ISO 3223): 74%
VOC Content: 264 g/lt
Flash point (ISO 3679): 32c
Dry Film thickness: 75-250 microns
Wet Film thickness: 100-340 microns
Theoretical coverage: 9.9-3.0 sq m/lt
Mix Ratio: 4:1
Pot Life 23c: 2 hrs
Touch Dry 23c: 1 hrs
Overcoat 23c: 2 hrs
Nozzle tip: 17-23 thou
Pressure at nozzle: 2100psi
Thinner: No. 17
H&S: Observe the precautionary information on the container. Refer to the MSDS for health and safety details and storage regulations.