RD Coatings Elastometal an Elastomeric Anticorrosion Waterproofing paint the economic alternative to Noxyde.
Elastometal has a life expectancy of over 15 years in C5-M environments
Elastometal requires no abrasive blast cleaning, prepare the surface using high pressure water jetting.
Elastometal is recommended for the renovation of metallic roofs in aggressive industrial locations.
Elastometal is an advanced environmentally compliant waterbased technology with zero emissions.
Elastometal has greater than 200% elasticity to allow expansion and contraction of metal panels.
Elastometal is for sale to Professional roofing contractors only, available in a wide range of RAL and NCS colour tones in a satin finish.
RD Coatings Elastometal is for the renovation of metallic roofs in aggressive industrial and marine environments. For sale to Professional roofing contractors only. Elastometal has excellent elasticity and anticorrosion properties, it is easy to apply without the need for abrasive blast cleaning. Elastometal is a Fast Drying water based coating and recommended as a maintenance roof coating for steel, cast iron, CorTen steel, weathered galvanised steel, aluminium, and plastisol coil coated sheets. Available in an extensive range of RAL & NCS colours in a satin finish.
RD Coatings Elastometal is a fast drying single pack waterbased anticorrosion and waterproofing primer finish for the restoration of metal roofs. It is suitable for harsh industrial and C5 marine environments, with a life expectancy of over 15 years. The elasticity is >200% preventing film defects on roofing subject to broad and frequent temperature changes. It is exterior durable without the need for abrasive blast cleaning on roofing and cladding. It can be applied by Airless spray, brush or roller on all types of substrates. Two coats are recommended on cast iron, steel and old galvanised roofs.
RD Coatings Elastometal is a single pack primer finish a cost effective solution for the renovation of metal roofing and cladding. It may be applied to CorTen steel, cast iron, aluminium, weathered galvanised steel sheets, plastisol and polyester powder coated sheet. It is a cost effective solution when renovating warehouses, factories, roofing and cladding. It can be applied in thick layers by airless spray, two coats of 175 µ dft each ar required to achieve a long lasting protection
Carbon Steel: Minimum St2 (ISO 8501-1), no abrasive blast cleaning required.
Old Galvanised steel: Surface to be clean and dry with a rough dull surface
New Galvanised steel: Use Multiprim primer
Aluminium: Surface to be clean and dry, abrade with non metallic abrasives or pads
Painted surfaces: Surface to be clean, dry and undamaged compatible coating, free from oil grease and other contaminants.
Volume Solids (ISO 3223): 56%
VOC Content: 8 g/lt
Flash point (ISO 3679): Non Flammable
Dry Film thickness: 350 microns
Wet Film thickness: 625 microns
Theoretical coverage: 8400g/sq m per 350 micron coat
Touch Dry 23c: 3 hrs
Overcoat 23c: 6 hrs
Nozzle tip: 15-23 thou
Pressure at nozzle: 2100psi,
Thinner: Water for airless spray only (3%)
H&S: Observe the precautionary information on the container. Refer to MSDS for full health and safety information and storage regulations.
|Choose Your Colour|
RAL1003, RAL1015, RAL1021, RAL1023, RAL2008, RAL3002, RAL3020, RAL5002, RAL5010, RAL5024, RAL6005, RAL6019, RAL6029, RAL7016, RAL7046, RAL8019, RAL9005, RAL9010, RAL9016
|Choose Pack Size|