Teamac Bituminious Paint an air drying bituminous paint for concrete and steel.
Teamac Bituminous Paint provides excellent water resistance in immersed conditions and above ground in marine environments.
Teamac Bituminous Paint is an ideal waterproof coating for concrete, steel, galvanised steel, brick and groundworks where excellent water resistance is required.
Teamac Bituminous Paint is an air drying marine finish it provides a tough abrasion resistant film above or below the water line.
Teamac Bituminous Paint is an economic waterproofing available in a black semigloss finish.
Teamac Bituminous Paint is ideal for concrete, steel, galvanised steel,brick walls, floors and groundworks where excellent water resistance is required. It provides a tough abrasion resistant film which can be used under water. It is recommended as a waterproof coating to stop the ingress of moisture in marine and industrial environments. It is available in a black semigloss finish.
Teamac Bituminous Paint is a solvent based high build bitumen off gloss coating for marine, industrial and agricultural applications, suitable for structural steel, galvanised substrates, wood, asphalt, concrete and brick walls. Teamac Bituminous Paint is a tough hard wearing coating with excellent water resistance suitable for immersion in water it forms a waterproof, weatherproof, corrosion resistant coating. Teamac Bituminous Paint is recommended for groundworks, piling and other marine applications it has excellent adhesion without the need for abrasive blast cleaning. Teamac Bituminous Paint is resistant to low levels of alkalis and acids and can withstand prolonged oxidation. It can be applied by airless or conventional spray, brush and roller.
Teamac Bituminous Paint is applied up to 40 microns per coat, two coats may be required to achieve the recommended DFT by brush or roller. It is an ideal coating for below the water line on canal barges, it is not suitable for potable water or aquatic fishponds.
Carbon steel: Min St 3 (ISO 8501-1).
Concrete: Surface to be clean and dry, free from oil grease and other contaminants.
Volume Solids (ISO 3223): 50%
VOC Content: 420g/lt
Flash point (ISO 3679): 32c
Dry Film thickness: 40 microns
Wet Film thickness: 80 microns
Theoretical coverage: 12 sq m/lt
Touch Dry 23c: 3 hrs
Overcoat 23c: 12 hrs
Nozzle tip: 18 thou Airless Spray, 2mm Conventional
Pressure at nozzle: 2100psi Airless, 60psi Conventional
H&S: Observe the precautionary information on the container. Refer to MSDS for full details on health and safety and storage regulations.