Zinga Galvanising Paint. Fast air drying Zinc Rich (96%) anticorrosion primer. Easy to Apply. Free Delivery.
Zinga provides cathodic protection to steel fabrications with a life expectancy in excess of 25 years in aggressive C5-M Marine and Heavy Industrial environments.
Zinga is an economic alternative to hot dip galvanizing or zinc metal spray. It can be applied by brush, roller, aerosol or spray. It may be left unpainted to provide anticorrosion resistance on steel structures or be overcoated with Penguard Tiecoat and Hardtop Polyurethanes for long term colour and protection.
Zinga is recommended for the protection of steel in aggressive marine C5-M environments and can be used as a repair system for galvanised steel. Zinga can be easily overcoated with itself as each new layer reliquidises itself forming a homogeneous layer and may be overcoated with polyester powder coatings and other high performance paints.
Zinga is Norsok approved to system one, it is available from stock in a wide range of pack sizes for free delivery throughout the UK.
Zinga is a fast air drying zinc rich epoxy primer with 96% zinc in the dry film and provides cathodic protection of ferrous metals. It can be used as a unique system as an alternative to hot dip galvanising or metallisation, as a primer in a duplex system or as a recharging primer for galvanised steel.
Zinga is designed for new construction where fast dry to handle and overcoating times are required. It is suitable for use on steel to be exposed to highly corrosive C5M environments. It can be applied by Airless spray on abrasive blast cleaned steel or by brush as a stripe coat for additional protection of welds. Zinga is prequalified in accordance with Norsok M501 System 1.
Zinga is an air drying zinc rich primer providing excellent corrosion protection as part of a complete coating system suitable for use in atmospheric environments. It can be applied direct to carbon steel and may be used to repair galvanised steel. It is recommended for offshore environments, structural steel, power plants, machinery, building products, construction and steel bridges. It can be applied up to 60 microns in a single coat by airless spray, two coats may be required to achieve the recommended DFT by brush.
Carbon Steel: Minimum Sa 2.5 (ISO 8501-1), on small areas St2
Galvanised steel: Surface to be clean and dry with a rough dull surface
Volume Solids (ISO 3223): 58%
VOC Content: 474 g/lt
Flash point (ISO 3679): 40c
Dry Film thickness: 60-90 microns
Wet Film thickness: 100-130 microns
Theoretical coverage: 10-8 sq m/lt
Touch Dry 23c: 20 mins
Overcoat 23c: 30 mins
Nozzle tip: 17-31 thou
Pressure at nozzle: 150 bari
Thinner: Zingasolv up to 15% by volume
H&S: Observe the precautionary information on the container. Refer to MSDS for full health and safety information and storage regulations.